Paper Feed From Multi-Purpose Tray (Mt) - Oki C7200 Service Manual

Service Guide - C7000 Series Page: 22
Chapter 2 Operation

(2) Paper Feed from Multi-Purpose Tray (MT)

1. The release lever usually pushes down the hopping plate to a position that turns microswitch on (Figure 2-7-a).
2. The running of the motor in the (a) direction drives the MT feed roller and turns the cam. The cam pushes the release lever and the hopping plate picks up
paper sent out by the MT feed roller (Figure 2-7-b), where the registration roller Assy (B) does not move because its one-way clutch gear (1) idles.
3. After the paper beginning turns the entrance sensor on, the paper is forwarded a fixed length. The paper stops when its beginning reaches the registration
roller Assy (B).
4. At the same time, the cam pushes down the hopping plate. The release lever that has been placed in its original position by the spring locks the hopping plate
(Figure 2-7-c).
5. After the completion of the paper feed operation, the registration motor runs in the arrow direction (b) to drive the registration roller Assy (B), where the
one-way clutch gear (2) does not allow the MT feed roller to move.