Oki C7200 Service Manual page 255

Service Guide - C7000 Series Page: 116
Chapter 4 Adjustments
4.2.3 EEPROM replacement after CRM board replacement
To replace the CRM board, remove the EEPROM on the board and include the EEPROM on a newly installed board (to allow a new board to inherit user-defined
settings and font installation information).
When the user's EEPROM is unusable due to its problem, use the new one on the new board, where the destination of the new board must be set. See Section
4.1.3 "CRM board adjustments" for the setting procedure.
Copyright 1999, Okidata, Division of OKI America, Inc. All rights reserved.