Oki C7200 Service Manual page 391

410: Yellow the four colors is
411: Magenta running short.
412: Cyan
413: Black
Remove Printed The stacker for
Papers 480: ejected papers is
Stacker Full full.
Load *** Papers The specified
490: No paper in cause has no
the MP Tray paper or is
(***=A4,B5 etc) removed. Or, the
cassette being
used for printing
has no more
paper.
Load *** Papers No paper in the
491 ~ 495: NO Cassette 1, 2, 3,
paper in the Tray 4 or 5 detected.
* (***=A4, B5
etc)
Replace Belt The belt counter
has reached the
life value.
Replace Fuser The fuser counter
has reached the
life value.
Job Offset Home The Job offset
Error assy does not
operate or cannot
detect the home
position.
Running Short of Running short of
Paper in Tray * paper detected
Disc Operation HDD can not be
Error written.
Copyright 1999, Okidata, Division of OKI America, Inc. All rights reserved.
almost empty?
2) Does the Toner sensor of the
specified cartridge operate normally?
1) Is the stacker full?
2) Does the Stacker full sensor operate
normally?
1) No paper in MT?
2) Does the Paper out sensor operate
normally?
1) No paper in the specified cassette?
2) Does the Paper out sensor operate
normally?
1) Is the error message displayed?
2) Does the error occur soon after Belt
unit replacement?
1) Is the error message displayed?
2) Does the error occur soon after
Fuser unit replacement?
Does the Job offset assy operate
normally?
Does only small amount of papers
(approx. 30 sheets or less) remain?
Is the operating procedure correct?
No toner kit. Replace the
Toner sensor for the
specified color.
Yes Remove papers from
No the stacker. Replace the
Stacker full sensor.
Yes Load papers in MT.
No Replace the Paper out
sensor.
Yes Load papers in the
No specified cassette.
Replace the Paper out
sensor of the specified
cassette.
Yes Check the belt life.
No Replace the Belt unit
immediately or at the
next maintenance.
Yes Check the fuser life.
No Replace the Fuser unit
immediately or at the
next maintenance.
Yes Replace the job offset
No sensor. Replace the Job
offset motor or Engine
board.
Yes Load papers.
No Check the Paper near
end sensor.
No Confirm the procedure
Yes in the manual. Replace
the HDD as it is broken.