Hitachi XP P9500 User Manual page 99

A temporary license key cannot be installed by using the dlnkmgr
command's set operation.
Example 1
The following example shows how to update the license key when
the license key file exists:
>dlnkmgr -l set -lic
KAPL01049-I Would you like to execute the operation?
Operation name = set [y/n]: y
KAPL01071-I A permanent license was installed.
>
Example 2
The following example shows how to update the license key when
the license key file does not exist:
>dlnkmgr -l set -lic
KAPL01049-I Would you like to execute the operation?
Operation name = set [y/n]: y
KAPL01083-I There is no license key file. File name
=Windows-installation-destination-drive-name\hdlm_license
KAPL01068-I Enter a license key:*************
KAPL01071-I A permanent license was installed.
>
-audlog {on [-audlv audit-log-data-collection-level] [-
category [[ss] [a] [ca]|all]]|off}
Specifies whether to collect audit log data.
on: Audit Log data is collected.
off: Audit Log data is not collected.
-audlv audit-log-data-collection-level
Specifies the severity level of audit log data to be collected.
6-4 Values Indicating Audit Log Data Collection Levels on page
6-19 describes the values that indicate audit log data collection
levels. The default is 6.
Table 6-4 Values Indicating Audit Log Data Collection Levels
Value (severity)
0
1
2
3
4
5
Command Reference
Hitachi Dynamic Link Manager User Guide (for VMware(R))
Error-level audit log data is collected.
Error-level and Warning-level audit log data is collected.
Explanation
Table
6-19