Switch Memory
Power Supply
Environmental Specifications for each Switch
Mechanical Specifications
The available memory for the FC 6164 is as follows:
• Main memory: 16 MB per switch
• Flash memory: 4 MB per bank, with 2 banks in the 2250 switch
(mirrored for redundancy)
The 2250 switch is powered on when the power cable is connected to the
switch and to a power source. The switch automatically performs a power
on self test (POST), which is a diagnostic test that takes approximately 2
minutes.
The 2250 switch has a universal power supply capable of functioning
worldwide without voltage jumpers or switches. The power supply module
is autoranging in terms of accommodating input voltages and line
frequencies.
Table 5. Power Supply Requirements
Total P/S power
Max. switch power
Input voltage
Input line frequency
Harmonic distortion
BTU rating
The acceptable environmental ranges for the 2250 switch are the same as
for the entire FC 6164, and are listed under
page
16.
70 to 120 W (70-W convection, without fan;
120-W with 30 CFM forced air, with fan)
60 to 70W
85 to 264 VAC
47 to 63 Hz
Power factor correction per IEC61000-3-2
110 W x 3.412 BTU/hr/W = 375 BTU/hr
"Thermal Characteristics"
on
21