Following is a description of the fields on the SNMP Admin tab.
System Description Displays or sets system description. Default is Fibre
System Location
System Contact
Event Trap Level
Enable
Authentication
Traps
Read Write
Community String
Read Only
Community String
Read Write and
Read Only Trap
Recipients
Commit SNMP
Changes
Reset
To disable the community string or trap recipient fields, leave them
Note
empty.
Channel Switch.
Displays or sets location of switch. Default is End
User Premise.
Displays or sets contact information for switch.
Default is Field Support.
Sets severity level of switch events that prompt
SNMP traps. Default is 0.
Click on to enable authentication traps; click off to
disable (recommended).
Displays or sets up to three strings that work with the
SNMP
command.
set
Displays or sets up to three strings that work with the
SNMP
command.
get or get-next
Displays or sets recipients for traps (usually IP
address of SNMP management station).
Click to apply changes made.
Click to reset all fields to values present when SNMP
Administration was launched.
169