HP Surestore 6164 - Switch Reference Manual page 42

42
If the rack you are mounting the switch in is on wheels,
WARNING
make sure the leveling feet are down or the wheels are locked to prevent
the rack from moving while you are installing the switch. Failure to
prevent the rack from moving could result in injury to personnel and/or
damage to the switch, the rack, or other equipment.
10.Insert the switch in the rack:
The FC 6164 weighs approximately 200 pounds. A lift is
WARNING
required to move and position the switch safely, and at least two people
are required to lift and position the switch onto the lift. Two or more
people are also required to move the switch from the lift into the rack
and when positioning the switch in the rack. Move the switch chassis
slowly and carefully at all times, and continue supporting it until it is
correctly positioned on the rail tray and fastened to the rack. Use
extreme caution when handling or transporting the switch to prevent
injury to personnel, damage to the switch, and/or damage to the rack and
other equipment mounted in it.
a. Place the switch on a lift. If you are installing the switch from the front
of the rack, orient the switch so its front end FACES THE FRONT OF
THE RACK is at the edge of the lift. If you are installing the switch
from the back of the rack, orient the switch so that its back end is at
the edge of the lift. (The switch must be installed so the front of the
switch faces the back of the rack.)
b. Position the lift close to the rack, and raise it until the bottom of the
switch is even with or very slightly above the top surfaces of the shim
plates that you positioned on top of the rail tray in Step 4.
c. Carefully slide the switch from the lift onto the shim plates on the rail
tray.
d. Position the switch so that its front end protrudes out the back of the
rack approximately six inches.
HP Surestore FC Switch 6164 Installation and Reference Guide