HP Surestore 6164 - Switch Reference Manual page 62

62
d. Disconnect each of the fiber optic cables from the faulty switch by
firmly grasping the connector housing (black) on the cable, and pulling
the cable from the GBIC.
4. Remove the switch from the chassis.
a. Unscrew the two 1/4-20 Phillips self-retaining screws that fasten the
switch brackets to the chassis (see
screwdriver.
b. Carefully move the cable harness out of the way so that the switch you
can slide forward without bending the cables.
c. Slide the switch forward and remove from the chassis.
5. Remove the two mounting brackets from the switch by unscrewing the
four 8-32 x 5/16 long Phillips panhead screws from each bracket. Set the
brackets and screws aside for the new switch.
Figure 23. FC 6164 with the Switch Mounting Brackets (Shown in Exploded
View)
HP Surestore FC Switch 6164 Installation and Reference Guide
Figure 23). Use a number 2 Phillips