Select Storage Pool For Logical Disk Creation Dialog Box - HP StorageWorks SN6000 - Fibre Channel Switch User Manual

NOTE:
you that a pool with fewer than three drives does not support fault-tolerant capacity optimized (RAID
5) and asks if you want to continue. Click Yes to continue or No to return to the Create Storage Pool
dialog box to change your selection.
e. Continue with
4. If the Select Storage Pool for Logical Disk Creation dialog box
following steps:
Figure 57

Select Storage Pool for Logical Disk Creation dialog box

a. Select one of the existing pool(s) that has space available for a new logical disk by selecting check
box next to the Storage Pool name. (If the pool has no space available, the check box is not visible.)
b. If the subsystem has unused drives, you can select the Create New Pool from available drives check
box to create another storage pool. If you select this check box, the Create Storage Pool dialog box
opens (see
c. If you want the storage subsystem to select the drives for the new logical disk, select the Do not
create the storage pool... check box near the bottom of the dialog box.
d. To close this dialog box and continue with logical disk creation, click OK. To close the dialog box
without selecting a storage pool, click Cancel.
A message box asks if you want to assign unused drives as spares. If you click Yes, the Assign Spare
Drive dialog box
92 Managing logical disks (LUNs)
If you choose to create a storage pool with fewer than three drives, a message box informs
step 6.
step 3) when you click OK.
(Figure 58) opens; go to
(Figure
step 5. If you click No, go to
57) opens, complete the
step 6.