Password To Change The Server's Hba Configuration Dialog Box - HP StorageWorks SN6000 - Fibre Channel Switch User Manual

If no specific server is selected, in the Available Server(s) list, select the server for which you want to
update the HBA driver:
• Select a server on the Available Server(s) list, and then click Add. This updates the driver of the
HBAs installed on this server.
• To add all of the listed servers, click Add All. This updates the driver of the HBAs installed on all
servers.
NOTE: If you select and add a server by mistake, select that server on the Selected Server(s) list,
and then click Remove. To clear the Selected Server(s) list and start the selection process again,
click Remove All.
3. Click Next. (Next is disabled until you select at least one server and add it to the Selected Server(s) list.)
4. In the List of HBAs to update driver, select the HBA you want to update, and then click Select HBA Driver
File.
5. Navigate to the folder containing either the Windows .exe file, or the Linux .gz, .rpm, .tar,
or .tgz file for the selected HBA.
6. Select the appropriate driver file, and then click Open.
The wizard's Driver File column shows the file name. The same driver file is automatically populated to
all the HBAs that belong to the same family, including HBAs on other servers.
7. Click Server Agent Password. (You must enter a valid password to complete this procedure.)
NOTE: The default Server Agent Password is config . To change this password for each server,
see "Setting a server agent password,"
8. In the Password to change the server's HBA configuration dialog box
and then click OK. The same password applies for all the HBAs in the server. If more than one server is
in the list, you must enter the password for each server.
Figure 45

Password to change the server's HBA configuration dialog box

The HBA Driver Update wizard
page 106.
(Figure 46) should now show all columns completed.
HP StorageWorks Simple SAN Connection Manager User Guide
(Figure 43), enter the password,
81