Code Memory Boxes; Programming An F-Code Memory Box - Sharp AR-FX12 Operation Manual

PROGRAMMING,
DELETING F-CODE MEMORY BOXES
The procedure for programming a memory box for F-code transmission is explained here. There are three types of
F-code memory boxes: F-code polling memory (page 4-4), F-code confidential transmission (page 4-6), and F-code
relay broadcast (page 4-8). Memory boxes are programmed, edited, and deleted as follows.

PROGRAMMING AN F-CODE MEMORY BOX

A box name, sub-address/passcode, and function must be programmed in a memory box.
NOTES
When programming a new memory box, a sub-address that is being used for another box cannot be used. The
passcode, however, can be the same as a passcode used in another box.
A passcode can be omitted.
Up to 100 F-code memory boxes can be programmed. If 100 F-code memory boxes have already been
programmed, a warning message will appear and you will not be able to program a new box. First delete an
unused F-code memory box (page 6-13) and then program the new box.
Press the [CUSTOM SETTINGS] key and
1
then touch the [ADDRESS CONTROL] key
(refer to steps 1 and 2 on page 6-2).
2 Touch the [F-CODE MEMORY BOX] key.
F-CODE MEMORY BOX
Touch one of the memory box keys ([POLLING
3
MEMORY], [CONFIDENTIAL],
BROADCAST] ) on the store (upper) line.
CUSTOM SETTINGS
F-CODE MEMORY BOX
STORE POLLING MEMORY
AMEND/DELETE POLLING MEMORY
([POLLING MEMORY] is touched in the example here.)
The F-code memory box programming screen appears
Touch the [BOX NAME] key.
4
F-CODE MEMORY BOX / POLLING MEMORY
No.001
BOX NAME
SUB ADRESS
POLLING TIMES
screen appears. Enter up to 18 characters for the name.
For information on entering characters, see
chapter 7 of the "Operation manual (for general
information and copier operation)".
6-10
O
or [RELAY
OK
RELAY
CONFIDENTIAL
BROADCAST
RELAY
CONFIDENTIAL
BROADCAST
The "No." that automatically
appears is the lowest
number from 001 to 100
that has not yet been
programmed. When the
[BOX NAME] key
touched, the letter-entry
EDITING,
Touch the [SUB ADDRESS] key.
5
F-CODE MEMORY BOX / POLLING MEMORY
No.001
BOX NAME FAX INFORMATION
SUB ADDRESS
POLLING TIMES
6 Use the numeric keys (0 through 9) to
enter a sub-address (max. 20 digits).
F-CODE MEMORY BOX / POLLING MEMORY
No.001
SUB ADDRESS / PASS CODE
ENTER THE SUB ADDRESS / PASS CODE VIA THE 10-KEY PAD,THEN PRESS [OK].
214341434
The characters "
sub-address.
If you enter an incorrect digit, press the [C] key and
re-enter the correct digit.
If you do not wish to enter a passcode, proceed to
step 9.
.
To set a passcode, touch the [PASS CODE]
7
key.
CANCEL
-KEY PAD,THEN PRESS [OK].
PASS CODE
is
AND
The sub-address/
passcode entry screen
appears.
NEXT EXIT
CANCEL
PASS CODE
" and "#" cannot be used in a
A slash (/) appears after
the sub-address.
OK
If you enter an incorrect
digit, press the [C] key
and re-enter the correct
digit
OK