Connecting Component (Bnc) Video - Epson PowerLite 8150i Administrator's Manual

Setting Up the Projector
30

Connecting Component (BNC) Video

If your video source has component (BNC) connectors, you can use
them to project a higher quality video image. Before starting, make
sure the projector and your video device are turned off.
1. Connect the three ends of a BNC cable into the projector's
and ports. (Don't connect the cables to the projector's H/C
B
Sync or VSync ports.)
2. Connect the red, green, and blue leads at the opposite end of the
cable to the corresponding connectors on your video source.
3. If the image doesn't display properly, you may need to change the
option in the projector's Setting menu to
BNC
page 79).
To use the projector's built-in sound system, connect the RCA audio
cable to the
S-Audio/Audio2
plug into the port and the red plug into the
L
plugs at the other end of the cable to the audio output ports of the
video source.
Computer 2/
Component Video
connectors
BNC cable
ports of the projector (insert the white
port). Connect the
R
, ,
R G
(see
YCbCr