Configuring The Projector To The Network; Determining How Your Network Is Set Up - Epson PowerLite 8150i Administrator's Manual

Setting up EasyMP.net
46
Configuring the Projector to the
Network
Make sure the projector is connected to your local area network
(LAN) and equipped with a memory card, as described in Chapter 1.
Then follow the steps below to configure your projector with the
correct TCP/IP address and other network parameters.

Determining How Your Network is Set Up

The way you configure your projector depends on how your existing
network is set up. Note any required parameters, as described below,
depending on the type of network you have in place.
Simple peer-to-peer network
You have a simple peer-to-peer network if it your equipment is
connected through a hub, as shown below:
Projector name : EasyMP.net
IP Address : 192. 168. 1. 1
Subnet Mask : 255. 255. 255.0
Default Gateway : x. x. x. x
Before configuring the projector, note the following information:
the first three octets of the IP addresses on the network (the first
three octets are the same for all devices):
Example:
the subnet mask
Hub
Computer name : PC5
IP Address : 192. 168. 1.5
Subnet Mask : 255. 255. 255.0
Default Gateway : x. x. x. x
192.168.1.10
first three octets
Computer name : PC10
IP Address : 192. 168. 1. 10
Subnet Mask : 255. 255. 255.0
Default Gateway : x. x. x. x