Connecting the Computer and Monitor Cables
1. If you'll be viewing images on a monitor as well as the projection
screen, connect the monitor cable to the projector's
port, as shown.
Computer 1
VGA port
Monitor Out
port
2. Connect one end of the VGA computer video cable to the
projector's
Computer 1
to your computer's monitor port.
3. Make sure the
Computer 1
switch is flipped to the right, as
shown. If necessary, use the tip
of a pen or a small screwdriver
to slide it over.
4. Tighten the screws on the
connectors.
VGA computer
video cable
(VGA) port, and connect the other end
Computer 1
Computer 2 /
Component Video
R/Cr/Pr
G/Y
B/Cb/Pb
H/C Sync
Remote
Mouse/Com
S-Video
S-Audio/Audio2
Video
L-Audio-R
Monitor Out
Stack Out
Monitor Out
monitor cable
Computer 1
switch
(slide to
right)
V Sync
Audio
Setting Up the Projector
note
If you're connecting to an
older Macintosh, you may
need a Macintosh adapter set.
See page 20.
19