Epson PowerLite 8150i Administrator's Manual page 27

note
You won't be able to view
images on a separate monitor
when the DVI port is in use.
Setting Up the Projector
26
Connecting to a High-End Workstation
Your PowerLite projector is capable of remapping input resolutions
up to 1600 1200 pixels. Since 1280 1024 pixels is the default
resolution for most leading workstations, your projector is ideal for
displaying workstation video output.
There is no standard for workstation video output. Workstations that
follow the SXGA standard and use the HD15 connector won't need
an adapter cable or any special connection device. However, your
system may vary; contact your computer dealer if you need help
connecting your workstation.
Connecting to a DVI Source
The projector's Digital Visual Interface (DVI) receives pictures
directly from your computer in digital format. This lets the projector
display images of greater clarity than can be achieved using a standard
analog VGA connection.
To project images in digital video format, follow these steps:
1. Connect the computer's DVI cable to the projector's DVI port.
DVI port
2. Using the tip of a pen or a small screwdriver, slide the
interface switch to the left. (If you need to use the
Computer 1
projector's VGA port again, be sure to slide the switch back to the
right.)
If you want to connect audio for this computer, plug the 3.5-mm
audio cable into the projector's
slide switch to left
Computer 1
Computer 2 /
Component Video
R/Cr/Pr G/Y B/Cb/Pb H/C Sync V Sync
Remote Audio
Mouse/Com
S-Video S-Audio/Audio2 Video L-Audio-R
Monitor Out
Stack Out
port.
Audio