Adjusting the Screen Image
Adjusting the Front Adjustable Feet
You can extend or retract the front adjustable feet to tilt the projector to
adjust the upward projection angle within a maximum range of 9º.
TIP
When using the front adjustable feet to adjust the angle of the
projector, it may cause keystone distortion to appear in the images. If
this happens, you can use the keystone correction function to correct
keystone distortion.
p.52
PROCEDURE
While pulling the two foot adjust levers at either side, lift
up the front of the projector so that the front adjustable
feet can extend.
Extend the front adjustable feet until the desired angle is obtained,
and then release the foot adjust levers.
To retract the front adjustable feet, gently push down on the projector
while pulling the foot adjust levers.
Foot adjust levers (side)
TIP
If the projector is tilted horizontally, the heights of the front
adjustable feet at left and right will not match each other. In this case,
you can either readjust the height using the foot adjust levers, or turn
the bases of the front adjustable feet to adjust the angle until the
projector is horizontal.
Front
adjustable foot
Extend
Retract
51