Projector Monitoring And Control Using A Network; Compatible Computers; Computers That Can Run Emp Monitor; Computers That Can Run Emp Networkmanager - Epson EMP-8300 User Manual

Projector Monitoring and Control using a Network

Computers and projectors can be connected together using a network so that
the statuses of the projectors can be monitored and controlled by computer via
the network.
A Projector Software CD-ROM is included as an accessory with this projector.
The Projector Software CD-ROM contains the EMP NetworkManager and
EMP Monitor software. This software can be used to carry out the following
network monitoring and control functions.
• EMP Monitor
This allows the statuses of projectors that are connected via a network to
be displayed on a computer monitor. Multiple projectors can be
monitored and controlled in this way using a single computer.
• EMP NetworkManager
This software is used to make network settings and e-mail notification
function settings for a projector using a computer. When EMP
NetworkManager is used to make mail notification function settings, e-
mail messages can be sent to a pre-designated e-mail address to notify the
computer operator when a problem occurs with a projector.
• Monitoring using SNMP
Projector status can be monitored and controlled from a computer using
SNMP. To use the SNMP function to monitor the projectors, you need to
install the SNMP software into the computer to be used for monitoring.
This should be done by a network administrator or someone else who is
familiar with the details of the network.
Carry out the following operations in the order listed in order to set up
monitoring and control of projectors via a network.
1. Use the Projector Software CD-ROM to install the software to be
used into the computer.
2. Connect the projector to the network using the a network cable.
p.101
3. Use the projector's configuration menus to make the required
network settings. p.102
4. Use the computer to monitor and control the projector.
Monitoring and control using EMP Monitor
Monitoring by means of the mail notification function
and the SNMP manager program
p.100
p.108
p.103

Compatible Computers

Computers that can run EMP Monitor

Windows 95/98 SE/Me/NT4.0/2000 Professional/
Operating System*
XP/XP Home Edition/XP Professional
Pentium MMX 166 MHz or higher
CPU
(Pentium II 233 MHz or higher recommended)
RAM 64 MB or more (128 MB or more recommended)
Free hard disk space 6 MB or more
XGA
Display
16-bit colour or greater
* Macintosh computers are not supported. If using Windows 95, you must
have Internet Explorer Ver. 3 or later installed.

Computers that can run EMP NetworkManager

Windows 98 SE/Me/NT4.0 (Service pack 6a or later)/
Operating System* 2000 Professional/XP/XP Home Edition/
XP TabletPC Edition
Pentium MMX 166 MHz or higher
CPU
(Pentium II 233 MHz or higher recommended)
RAM 7 MB or more (10 MB or more recommended)
Free hard disk space 250 KB or more
XGA
Display
16-bit colour or greater
* Macintosh computers are not supported.
(1024 × 768) resolution or higher,
(1024 × 768) resolution or higher,
99