Epson EMP-8300 User Manual page 119

Problem Solving Problem Solving
Status
Lamp replacement notification
Orange
Standby condition
Orange
Warm-up in progress
Green
Projection in progress
Green
Cool-down in progress
Orange
Cause
Replace the lamp with a new one.
If you continue to use the lamp after it has passed the replacement period, the possibility that the
lamp may break will increase. Replace the lamp with a new one as soon as possible.
* The indicator status will vary depending on the projector status at the time.
(Not abnormal)
Press the [Power] button on either the remote control or the projector's control panel to start
projection.
When turning off the projector's power, disconnect the power plug from the electrical outlet when
the projector is in this condition.
(Not abnormal)
Please wait. Warm-up time is approximately 40 seconds. After warm-up is complete, the flashing
green indicator changes to steady green.
(Not abnormal)
(Not abnormal)
Please wait.
•The cool-down
ambient air temperature.)
•You cannot operate the [Power] button on either the remote control or the projector's control
panel during cool-down. Press the button again after cool-down ends and the indicator changes to
steady orange.
Remedy or Status
p.133
period lasts about 30 seconds. (This varies depending on factors such as the
118
: lit : flashing : off