Turning the Projector On
Turning the Power On and Projecting Images
TIP
With the EMP-9300, the Password Protect setting may cause the
password entry screen to be displayed when the power is turned on.
If this happens, enter the password.
Check that the
indicator has stopped flashing and
1
is lit orange.
If using the remote control, set the [R/C] switch on the
2
remote control to "ON".
Turn the power on for all equipment connected to the
3
projector.
For a video source, press the [Play] button at the video source to
start playback if necessary.
p.36
Press the [Power] button on either the remote control
4
or the projector's control panel to turn the power on
for the projector.
The
indicator flashes green. After a short period it stops
flashing and lights steadily, and projection starts.
Wait until the
indicator lights green (it normally takes about
40 seconds to change).
Remote control
TIP
• The remote control and projector's control panel buttons will not
function while the
indicator is flashing green.
• Depending on the configuration menu settings, the message "No
Signal." may appear. See "Setting" - "No-Signal Msg."
42
Changes from flashing to lit green
p.85