Safety Precautions - Craftsman 320.28060 Owner's Manual

I WARNING:
BE SURE to read and understand all instructions.
Failure to follow all instructions listed below may result in electric
shock, tire and!or serious personal injury
SAFETY PRECAUTIONS FOR LASER
This saw has a built-in laser light.. The laser is a Class Ilia and emits output power of a maximum
1mW and 400nm - 700nm wavelengths. These lasers do not normally present an optical hazard
However, DO NOT stare at the beam because it can cause flash blindness
IMPORTANT: The following label is on your saw. It indicates
where the laser light is emitted by the saw. ALWAYS BE AWARE
of its location when using the saw and ALWAYS MAKE SURE
that any bystanders in the vicinity of use are made aware
of the dangers of looking directly into the laser.
!
AVOID EXPOSURE
LASER RADIATION EMITTED
FROM THIS APERTURE
I _ WARNING: LASER LIGHT. LASER RADIAT;O'N'"Avoi'd Direc;'Eye'Exp'osure 'Do Not I
Stare into beam Only turn laser beam on when tool is on the workpiece. Class 11 la
I WARNING:
DO NOT stare directly at the laser beam.. A hazard may exist if you I
deliberately stare into the beam. ALWAYS follow the following safety precautions when
!
using this saw, ,.........
1. The tinted glasses that were included will enhance the laser light in bright light conditions
DO NOT wear these glasses if they interfere with the safe operation of this saw.1
2. NEVER aim the beam at any person or object other than the workpieceo
3. The laser beam can be harmful to the eyes° ALWAYS avoid direct eye
exposure,, DO NOT look directly into the laser beam output aperture
during operation.
4, The laser on the saw is not a toy ALWAYS keep out of the reach of children,.
The laser light emitted from this device SHOULD NEVER be directed towards
any person, for any reason.
5. ALWAYS be sure the laser beam is aimed at a sturdy workpiece (such as wood or rough
coated surfaces) that does not have a reflective surface