Craftsman 320.28060 Owner's Manual page 11

ADDITIONAL RULES FOR SAFE OPERATION conL
9_ALWAYS inspect and remove all nails from lumber before sawing.
10. DO NOT use the tool while tired or under the influence of drugs, alcohol or any
medication.
11_ SAVETHESE INSTRUCTIONS. Refer to them frequently and use them to instruct others
who may use this toolo If someone borrows this tool, make sure they have these
instructions also.
,,,, ,,H = =u , =, H, ,,,,, ==u ,, ,ul ,,, ==,u ,=,=,,,,=
Z_ WARNING:
The operation of any circular saw can result in foreign
objects being thrown into your eyes, which can result in severe eye damage.,
Before beginning power toot operation, ALWAYS wear safety goggles or
safety glasses with side shield and a full face shield when needed. We
recommend A Wide Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shield, available at Sears Retail Stores,
: ,1 H,,,,,l= ,,, ,,, ,,,,,,1
=' ,= ,,,,,, =,= = ,,,,,,,,,,,,n ,t,,,=lt, l,l,, H =,,,, ,u,t
Z_ WARNING:
Some dust particles created by power sanding, sawing, grinding,
drilling and other construction jobs contains chemicals known to cause cancer, birth
defects or other reproductiveharm. Some examples of these chemicals are:
• Lead from lead-based paints
. Crystalline silica from bricks and cement and other masonry products.
• Arsenic and chromium from chemically4reated lumber.
Your risk from these exposures varies, depending upon how often you do
this type of work To reduce your exposure to these chemicals:
• Work in a well-ventilated area
• Work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles,
uu, , ,,,,, ,,,, , ,i
The label on your tool may include the following symbols.
V ........................................... Volts
A................................... Amperes
Hz .................................... Hertz
W ........................................... Watts
min ....................................... Minutes
............................. Alternating current
Direct current
no .................................... No-load speed
[] ..................................... Class It construction
,, train ................................. Revolutions or Strokes per minute
/t',, .............................. Indicates danger, warning or caution.
It means attention! Your safety is involved..
IMPORTANT! READ ALL INSTRUCTIONS
1 '1