RULES FOR SAFE OPERATION
BE SURE to read and understand atl instructions. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious personal injury°
1. Know your power tool. Read operator's manual carefully. Learn the applications
limitations, as well as the specific potential hazards related to this tool.
2. ALWAYS wear safety glasses or eye shields when using this saw. Everyday eyeglasses
have only impact-resistant
lenses; they are NOT safety glasses.
3. ALWAYS protect your lungs. Wear a face mask or dust mask if the operation is dusty.
4. ALWAYS protect your hearing. Wear hearing protection during extended
5. ALWAYS inspect the tool cords periodically and if damaged have them repaired at
your nearest Sears Service Center or other Authorized Service
Facility. ALWAYS be
aware of the cord location.
6. ALWAYS check for damaged parts. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine if it will operate
properly and perform its intended
function. Check for misalignment
or binding of
moving parts, breakage of parts, and any other condition that may affect the tool's
operation. A guard or other part that is damaged, should be properly repaired or
replaced at a Sears Service Center.
7. DO NOT abuse the cord. NEVER use the cord to carry the tool or pull the plug from
the outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace
damaged cords immediately. Damaged cords increase the risk of etectric shock,
8, ALWAYS make sure that your extension cord is in good condition, When using an
cord be sure to use one that is heavy enough to carry the current
your tool will draw. A wire gauge (AWG) of at least 14 is recommended
for an extension
cord 25 feet or Eessin length When working outdoors ALWAYS use an extension cord
that is suitable for outdoor use, The cord's jacket win be marked WA
wires, have greater
capacity (16 gauge wire has more capacity than 18 gauge wire).
An undersized cord will cause a drop in line voltage, resulting in ross of power and overheating