Gui Event Display; Fault Management Displays; Displaying Last Fault Information; Typical Hp Command View Eva Event Display - HP StorageWorks 6400/8400 - Enterprise Virtual Array User Manual

• Code Flag—An internal code that includes a combination of other flags.
• Description—The condition that generated the event. This field may contain information about an
individual field's content and validity.

GUI event display

A problem that generates the Event display reduces the system capabilities. You can use the information
in this display (see
NOTE:
The major differences between the Event Display and the Termination Event display are:
The Event display includes an EIP type field; it does not include a Code Flag field.
The Event display includes a Corrective Action Code (CAC) field.
The Termination Event display includes a Code Flag field; it does not include the EIP Type field.
Date Time
Figure 28 Typical HP Command View EVA Event display
.
The Event display provides the following information:
• Date—The date the event occurred.
• Time—The time the even occurred.
• SWCID—Software Identification Code. A number in the range 1 256 that identifies the internal
firmware module affected.
• Evt No—Event Number. A hexadecimal number in the range 0 FF that is the software component
identification number.
• CAC—Corrective Action Code. A specific action to correct the problem.
• EIP Type—Event Information Packet Type. A hexadecimal character that defines the event inform-
ation format.
• Description—The problem that generated the event.

Fault management displays

When you do not have access to the GUI, you can display and analyze termination codes (TCs) on
the OCP LCD display. You can then use the event text code document, as described in the section
titled "Interpreting Fault Management Information" to determine and implement corrective action. You
can also provide this information to the authorized service representative should you require additional
support. This lets the service representative identify the tools and components required to correct the
condition in the shortest possible time.
When the fault management display is active, you can either display the last fault or display detailed
information about the last 32 faults reported.

Displaying Last Fault Information

Complete the following procedure to display Last Fault information
1.
When the Fault Management display is active, press
94 Controller fault management
Figure 28) to diagnose and correct problems.
SWCID Evt No CAC EIP Type
to select the Last Fault menu.
Description