Replotting With Hp-Gl/2 Jobs Is Not Possible; The Printer Stops When Printing A Hp-Gl/2 Job (The Carriage Stops Moving) - Canon imagePROGRAF iPF750 MFP M40 User Manual

Replotting with HP-GL/2 jobs is not possible.

Cause
The data was lost be-
cause of replotting.

The printer stops when printing a HP-GL/2 job (the carriage stops moving)

The printer is analyzing the print job.
A job was printed when Input Resolution in the
Control Panel menu was set to 600dpi.
iPF750
Data for replotting is lost after the following operations. In this case, send the print job again.
• The memory buffer was cleared from the Control Panel.
• The printer was turned off.
• The printer has received a new HP-GL/2 print job.
• Printing has been canceled
Cause
Corrective Action
Corrective Action
Please wait a while until printing is finished.
In the Control Panel menu, set Input Resolution to 300dpi and
print again.
(See "Menu Settings.")
→P.673
Replotting with HP-GL/2 jobs is not possible.
Troubleshooting > HP-GL/2 problems >
11
801