Hp-Gl/2 Printing Takes A Long Time; Replotting With Hp-Gl/2 Jobs Is Not Possible - Canon imagePROGRAF iPF605 User Manual

HP-GL/2 printing takes a long time.

Large print jobs with a lot of data take longer to print. On the printer Control Panel, set Input Resolution to

Replotting with HP-GL/2 jobs is not possible.

The data was lost because of replotting.
The printer stops when printing a HP-GL/2 job (the
carriage stops moving)
The printer is analyzing the print job.
Cause
Cause
Cause
Corrective Action
300dpi.
(→P.55)
Corrective Action
Data for replotting is lost after the following
operations. In this case, send the print job again.
•
The memory buffer was cleared from the Control
Panel.
•
The printer was turned off.
•
The printer has received a new HP-GL/2 print job.
•
Printing has been canceled
Corrective Action
Either wait a while for printing to resume, or on
the printer Control Panel, set Input Resolution to
300dpi.
(→P.55)
HP-GL/2 problems
Troubleshooting 531