iPF760
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified
Cause
The page size of the HP-GL/2 print job, as created in the
source application, is incorrect.
HP-GL/2 printing takes a long time
HP-GL/2 printing takes a long time
Large print jobs with a lot of data take longer to print.
A job was printed when Input Resolution in the Control Panel
menu was set to 600dpi.
Replotting with HP-GL/2 jobs is not possible.
Replotting with HP-GL/2 jobs is not possible.
Cause
The data was lost because of replotting.
The printer stops when printing a HP-GL/2 job (the carriage stops moving)
The printer stops when printing a HP-GL/2 job (the carriage stops moving)
The printer is analyzing the print job.
A job was printed when Input Resolution in the Control Pan-
el menu was set to 600dpi.
User's Guide
Cause
Data for replotting is lost after the following operations. In this case, send the print job again.
•
The memory buffer was cleared from the Control Panel.
•
The printer was turned off.
•
The printer has received a new HP-GL/2 print job.
•
Printing has been canceled
Cause
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified
Corrective Action
In the Control Panel menu, set PageSizeProcess2 or Conserve Paper to On.
The layout will be changed to the optimal layout.
(See "Menu Settings.")
→P.448
Please wait a while until printing is finished.
In the Control Panel menu, set Input Resolution to 300dpi and print
again.
(See "Menu Settings.")
Corrective Action
Please wait a while until printing is finished.
In the Control Panel menu, set Input Resolution to 300dpi and print
again.
(See "Menu Settings.")
→P.448
Corrective Action
→P.448
Corrective Action
571