Panasonic Digital Palmcoder PalmSight PV-DV900 Operating Instructions Manual page 50

High quality digital-to-digital copying can be accomplished if both Palmcorders incorporate
the digital in/out IEEE1394 interface (DV interface cable is not supplied).
Before you begin...
• Connect both Palmcorders to their power
sources.
• Connect the two digital Palmcorders using
the DV interface cable (not supplied).
• Turn both Palmcorders ON.
(Playing)
Palmcorder
Insert a pre-recorded tape into the
source (playing) Palmcorder, turn on,
and set the POWER Switch to VCR.
Insert a blank tape with the record
tab in place into the target (recording)
Palmcorder turn on, and set the
POWER Switch to VCR.
DV Input/
Output
Connector
Editing
(Recording)
Palmcorder
DV Interface Cable
(not supplied)
_=.=_" _PLAY4 '.fILl I
ST'OP P USE
Press PLAY on the source Palmcorder.
When the tape reaches the point you
want to start dubbing, press PAUSE.
On the remote control (Optional, page
53), hold down the REC button and
press PLAY.
Press PAUSE to pause the tape at the
starting point of the dub.
Simultaneously, press the PAUSE
Buttons on both units to begin the
dubbing.
Press the STOP Button on recording
unit, and then press STOP Button on
playing unit to end dubbing.
Note:
• When two Palmcorders are used for
dubbing, it is recommend that the remote
control VCR1 or VCR2 setting be used to
avoid mis-operation.
• When two Palmcorders are connected
using the DV interface cable (not
supplied), a Video Editing Controller
cannot be used.
Ic UCAUTION:
nauthorized exchanging and/or copying of |
opyrighted recordings may be copyright
J
nfringement.
50 For assistance, call 1-800-211-PANA(7262)