Panasonic Digital Palmcoder PalmSight PV-DV900 Operating Instructions Manual page 48

PAUSE
To listen to the desired audio sound, set the
AUDIO setting of the VCR mode MENU
(page 19) as follows:
AUDIO (The following selections are
available 12bit AUDIO dubbed
recording only)
ST1 Set this position to listen to the
original sound.
ST2 Set this position to listen to the
audio dubbed sound.
MIX Set this position to listen to both
the original sound and the audio
dubbed sound.
Note:
• 16bit dubbed sound completely erases the
original 16bit recorded sound.
• If you select 12bit AUDIO recording and
dubbed the sound with the AUDIO-MIX
on, the sound will be stereo regardless of
the AUDIO-OUT setting.
• If you recorded in LP mode, you can not
use the A-DUB feature.
Press PAUSE to start Audio Dubbing.
Connect Palmcorder to TV in order to
monitor the sound. (see page 37)
A-DUB
J
Only NTSC (National Television Standards
Committee) recorded tapes can be audio
dubbed. The following screen appears if
the tape was not recorded in NTSC format.
INCOMPATIBLE
TAPE
Press PAUSE to stop Audio Dubbing.
• If the microphone used for dubbing gets
too near the speaker of your TV,
a howling noise (feedback) may occur.
• If the tape position lies or starts in a blank
section, you can not use the A-DUB fea-
ture.
You can set an automatic Edit stopping point.
Before step 2, locate the point at which you
want the dubbing to stop.
Press MENU and set DISPLAY to
MEMORY (page 18).
Then, press RESET on the remote control
to reset the Counter Memory to
M 0:00:00.
Now, rewind to the editing start point,
and continue with steps 2-5. The tape will
now stop automatically at "M 0:00:00".
48
For assistance, call 1-800-211-PANA(7262)