Panasonic Digital Palmcoder PalmSight PV-DV900 Operating Instructions Manual page 27

I_"]l iiTo] _ ;(=.l'(o] i[a IIi[_ I
Remove the lens cap and clip it to the hook.
Built-In Twin
Capsule 2-Way
Microphone
System _
POWER ---_.
Lamp _
REC Lamp
Before you begin...
• Connect the Palmcorder to a power source.
• Insert a cassette with record tab closed
(see page 14).
_ Tally LED
) POWER
Y Switch
RECORD/
/ PAUSE
Button
1
2
Set POWER Switch to CAMERA.
• The POWER lamp lights red.
EVF
PAUSE 1
Record/Pause mode.
With the Viewfinder Eye Cup up to
your eye, adjust the Vision
Adjustment Control to your eyesight.
(page 8)
WARNING:
• Do not lift or carry the Palmcorder by the
EVF or by the LCD Monitor.
X _ "\
3
Press RECORD/PAUSE Button to
start recording.
The Tally LED and REC Lamp will be
on.
To turn the Tally LED off, see TALLY
LED on page 18.
Press RECORD/PAUSE Button again
t_ recording.
• To reduce microphone wind noise, set
the WIND-CUT to ON (see
WIND-CUT on page 18).
• When the Palmcorder is aimed at
excessively bright objects, or bright lights,
a vertical bar may appear in the picture.
This is a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
possible.
- To conserve power
After 5 minutes, the Record/Pause mode will
automatically change to Standby mode.
To resume recording, set POWER to OFF and
then ON again.
For assistance, call 1-800-211-PANA(7262)
27