Panasonic Digital Palmcoder PalmSight PV-DV900 Operating Instructions Manual page 37

_TV with AUDIO/VIDEO IN Jacks._
Set the POWER Switch to CAMERA,
You can now view what the Palmcorder
is recording on your TV.
Or, to playback a tape, set the
OUT POWER Switch to VCR.
You can now playback a recorded tape
on your TV.
Turn your "IV ON and set it to LINE
INPUT or S-VIDEO.
Check your TV operating instructions for further information.
-A/V Cable
(Supplied)
To n_'V o
Audio I ideo In
Audio In "deo/, i 3otSe
, _ _ tart: playback or begin a recording.
I I _ • Please connect the AN cable until it stops.
• Make sure the Palmcorder and TV are turned
off while connecting.
_TV with S-VIDEO IN Jacks._
For best Chrominance and Luminance it is
suggested to use the S-Video connection if
available on your TV.
p._Tiilta_l]
OUT
OUT
in_ |[.] .l_.lll :f-..] i n[e](--IL_o]a|qiH I[Im Lvi i_. [_| |
You can display the various EVF
indications on your TV by pressing
DISPLAY ON TV on remote control. Press
again to remove the indications.
DISPLAY-
o. v I l+
0
L$ [_:
_'_ack °' 71
Audio In S-Video In
-AV Cable
t i
(Supplied) II I
To Audio In @
_
\ S-Video Cable To S-Video In
(Not supplied)
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
the Canadian Electrical code in Canada
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be connected
to the grounding system of the building,
as close to the point of cable entry as
_,practical.
For assistance, call 1-800-211-PANA(7262)
37