Panasonic Digital Palmcoder PalmSight PV-DV900 Operating Instructions Manual page 49

Before you begin...
• Connect the Palmcorder and the Jack Box
(see page 36).
• Connect both Palmcorder and VCR to their
power sources.
• Connect the Palmcorder to a VCR as
illustrated below.
• Turn ON both units.
• Set the recording VOR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER Switch to VCR.
Source
(Playing)
Llmcorder
Insert a pre-recorded tape
into the source (playing) Palmcorder
and a blank tape with record tab in place
into the target VCR (Recorder).
Press PLAY on the Palmcorder. When
the tape reaches the point you want to
start dubbing, press PAUSE.
Press REC or simultaneously REC
and PLAY (depends on VCR) and then
pause the recorder.
'AJV OUT
A/V Cable
(Supplied)
"_S-VIDEO
OUT
I TV
(To View)
USE/STILL STOp REW PLAY FF
VCR Buttons
Simultaneously, press PAUSE on
both units to begin the copying.
=gCable _-,-,-,-,-,-,-,-,-,,_ Press STOP on both units when
(not supplied) copying is complete.
To Audio In Audio In Video In
Recording:
VCR (Rear)
S-Video In
To Video In To S-Video In
(If there is S-Video In)
F dn'lW ]UrdinkVA
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
Notes:
• For technical reasons, dubbing a tape may
reduce its quality.
• Press DISPLAY on the Palmcorder remote
control to eliminate EVF/LCD Monitor indications
to be recorded on the tape. Eliminate all OSD
functions on the VCR as well.
• If the Time Code is displayed in the EVF or LCD
monitor, this display cannot be reset.
CAUTION:
nauthorized exchanging and/or copying ofJ
opyrighted recordings may be copyright
nfringement.
For assistance, call 1-800-211-PANA(7262)