Panasonic Digital Palmcoder PalmSight PV-DV900 Operating Instructions Manual page 31

You can control any two PV-DV900's
with one Remote control (Optional, page
53). In order for the remote to
distinguish between the two units, it is
necessary to set one of the Palmcorders
to VCR 2. On the remote, press VCR 1
or VCR 2 to control the desired
Palmcorder.
For VCR 2 :
Press these --=
buttons at
same time.
For VCR 1 :
_Press these
buttons at
same time.
Display the menu and select REMOTE
VCR 2 on one Palmcorder (page 18).
Leave the other Palmcorder set to
VCRI.
Set the Remote Control (Optional,
page 53) to VCR 1 or VCR 2 to
correspond with the Palmcorder you
wish to control. (See illustration at left.)
Note:
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE" will
appear,
REMOTE 1
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
a
Insert a slender, pointed
object, such as the tip of a
ball-point pen into the slot so
that it fits into the hole (as
shown a). Then, while sliding
to the right, pull the battery
holder out with your fingernail.
Insert the battery into the
Battery Tray with the C) mark
facing up.
Do not reverse the polarity.
Replace the Battery Tray.
'-Replace battery with
Panasonic PART NO.
VSBW0004 (CR2025) only.
Use of another battery may
present a risk of fire or
explosion.
Caution-battery may
explode if mistreated.
Dispose of used battery
promptly. Keep away from
children. Do not recharge,
disassemble or dispose of
in fire.
For assistance, call 1-800-211-PANA(7262)
31