HP Compaq 8510p - Compaq Business Notebook Maintenance And Service Manual page 91

Before removing the speaker assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. TouchPad (see
f. Display assembly (see
g. Top cover (see
Remove the speaker assembly:
1. Disconnect the speaker cable (1) from the system board.
2. Remove the three Phillips PM2.5×4.0 screws (2) that secure the speaker assembly to the base
enclosure.
3. Remove the speaker assembly (3) from the base enclosure.
Reverse this procedure to install the speaker assembly.
Battery on page 45).
Hard drive on page 49)
Optical drive on page
Keyboard on page 57)
Switch cover on page
TouchPad on page 67)
Display assembly on page
Top cover on page 80)
53)
71)
75)
Component replacement procedures 83