Securing The Rack Mount Brackets; Sliding The Switch Into An Hp 9000 Series Rack; Connecting Ac - HP StorageWorks 2/16 - SAN Switch Installation Manual

Installing the SAN Switch 2/16
3. Slide the switch in the rack, see
Figure 7: Sliding the switch into an HP 9000 Series rack

Securing the Rack Mount Brackets

Secure the rack mount brackets (installed earlier, see
Rack Mount
1. Locate two Phillips head 10-32 x 3/8" screws in the Rack Mount Kit
2. Secure each rack mount bracket to the rack rails.
3. Tighten the screws, and torque to 25-inch pounds.
4. See the
38
Brackets," on page 32) to the HP 9000 Series rack rails, as follows.
accessory pouch.

"Connecting AC

power to the switch.
Figure 7.
Power" on page 45, for instructions on applying
hp StorageWorks SAN Switch 2/16 Installation Guide
SHR-2476A
"Attaching the Rear or Front