HP StorageWorks 2/16 - SAN Switch Installation Manual page 104

Glossary
Single Mode
The fiber optic cabling standard that corresponds to distances of up to 10 km between
devices.
SNMP
Simple Network Management Protocol. An internet management protocol that uses either
IP for network-level functions and UDP for transport-level functions, or TCP/IP for both.
Can be made available over other protocols, such as UDP/IP, because it does not rely on the
underlying communication protocols.
Switch Name
The arbitrary name assigned to a switch.
Switch Port
A port on a switch. Switch ports can be E_Ports, F_Ports, or FL_Ports.
Switch
Hardware that routes frames according to Fibre Channel protocol and is controlled by
software.
Target
A storage device on a Fibre Channel network.
Tenancy
The time from when a port wins arbitration in a loop until the same port returns to the
monitoring state. Also referred to as loop tenancy.
Throughput
The rate of data flow achieved within a cable, link, or system. Usually measured in bps (bits
per second).
Topology
As applies to Fibre Channel, the configuration of the Fibre Channel network and the
resulting communication paths allowed. There are three possible topologies:
Point to point - A direct link between two communication ports.
Switched fabric - Multiple N_Ports linked to a switch by F_Ports.
Arbitrated loop - Multiple NL_Ports connected in a loop.
Transfer State
The state in which a port can establish circuits with multiple ports without reentering the
arbitration cycle for each circuit. This state can only be accessed by an L_Port in the Open
state.
Translative Mode
A mode in which private devices can communicate with public devices across the fabric.
104 hp StorageWorks SAN Switch 2/16 Installation Guide