Operation; Powering On The Vls12000 System; Vls12000 Node Led Status During Normal Operation - HP StorageWorks 12000 - Virtual Library System EVA Gateway User Manual

7 Operation

This section describes how to power on and power off the nodes.

Powering on the VLS12000 System

1. Power on all arrays connected to the VLS.
2. Power on the two private LAN switches connected to the VLS.
3. Plug the VLS nodes' AC power cords into a power source if not already connected.
4. Press the VLS secondary nodes' Power On/Standby button. After the secondary nodes are
powering up, press the primary node's Power On/Standby button.
5. Confirm that the VLS components are all functioning normally and the VLS is cabled correctly by
observing the condition of their status LEDs. The LED status should match those shown in the
following table.
If an LED status does not match the status shown in the following table, a component needs
attention.
Figure 25 VLS12000 node LED status during normal operation
.
Item
1
2
3
4
5
Description
Internal health LED
External health LED (power supply)
NIC 1 link LED
NIC 2 link LED
Power supply LEDs
Status
LED is green.
LED is green.
LED is green if primary node. LED is off if
secondary node.
LED is green.
LED is green.
HP StorageWorks 99