Editing A Virtual Library's Slots And Drives; Creating Tape Drives - HP StorageWorks 12000 - Virtual Library System EVA Gateway User Manual

11. Click Next Step.
A window opens indicating that by default all libraries connected to the VLS have access to all
hosts.
12. Click Create Library.
A summary window opens and displays details about the library emulation created.
13. Choose one of the following options:
• To perform LUN mapping for the virtual library, click Map LUNs and proceed to
"LUN Mapping
• To continue creating the virtual library, click Create Tape Drives and proceed to
"Creating Tape
• To exit the wizard, click Cancel.
The library is created but does not contain any tape drives or cartridges. You can add tape
drives and cartridges later.

Editing a Virtual Library's Slots and Drives

To edit the slots and drives of a virtual library:
1. Open a Command View VLS session and log in as the administrator. See
"Opening a Command View VLS Session from a Web
2. Select the System tab.
3. Expand Chassis in the navigation pane.
4. Select Virtual Libraries in the navigation pane.
5. Select Edit Virtual Libraries in the task bar.
6. On the Edit Virtual Libraries screen, select the library you want to edit from the list.
7. Change the number of slots and/or the number of drives in the appropriate fields.
8. Select Next. A warning message indicates that some services will stop if you make any changes.
9. Select Edit Library to continue. The screen displays a "please wait" message.
You may select Return to cancel if you decide not to make the change.
10. Log out of the GUI and close the browser window. Log back in approximately fifteen minutes
later.
This manual disconnect ensures that the edit screens refresh.
11. Check the library you edited on the System tab to verify the change.

Creating Tape Drives

NOTE:
If you add a virtual tape drive to a library after another library has been created, the default LUN
number assigned to the tape drive will not be consecutive with the other virtual tape drives in the same
library. To correct this, restart the VLS device emulations. See
"Restarting VLS Device
numbers on the VLS so that all the default tape drive LUNs in a library are consecutive.
(v3.x)" on page 123 for further instructions.
Drives" on page 133.
Emulations" on page 147. The VLS firmware will change the virtual device LUN
Browser" on page 105.
HP StorageWorks 133