Installing The 1 Gb Ethernet Switch 2810 24G Into A Rack - HP StorageWorks 12000 - Virtual Library System EVA Gateway User Manual

1. Locate the rail kit — part number 360332 003.
Install the two outer slide rails to the rack. The outer rails are marked "FRONT" and "REAR."
On both sides of the rack, align the rail holes with the holes in the rack and secure.
2. Attach the inner rails to the sides of the node.
Align the holes in the rail with the round tabs on the side of the node.
NOTE:
The inner rails are identical.
The word "FRONT" should face away from the node, but will appear updside-down on one
side.
3. Align the rails on the node with the rails in the rack, and slide the node fully into the rack.
4. Tighten the thumbscrews.

Installing the 1 Gb Ethernet Switch 2810 24G into a Rack

Installing the switch into the rack involves installing the cage nuts and rail flanges, attaching the rails
to the switch, and installing the switch into the rack.
HP StorageWorks 23