Using Bindery Print Server (Netware 3.X/4.X) - Epson Color Laser Printer Owner's Manual

Time required to recognize the print server
It takes up to two minutes for the NetWare server to recognize
the print server, after the printer is turned on. During this
start-up time, the status sheet does not show the correct
information.
Frame type
The same frame type should be used for the NetWare server
and IPX router on the same network. If more than one frame
type is used on the same network, bind all the frame types to
the NetWare servers and IPX routers.
For NetWare 5.x
The IPX protocol must be installed (bound) on the
NetWare 5.x server.
About modes
If the mode you have logged in is different from the mode you
set for the print server, a message appears when you try to
configure the print server for NetWare. If you do not want to
change the current settings, click Cancel and log in again
using the same mode set for the print server.

Using Bindery Print Server (NetWare 3.x/4.x)

This section contains instructions on using the print server in the
Print Server mode on NetWare 3.x/4.x/IntranetWare with
Bindery emulation.
Note:
The print server in the Print Server mode of NetWare 3.x does not allow
you to use the Print Server status display control with PCONSOLE.
1. Turn on your printer.
134
Settings for NetWare Server