Epson Color Laser Printer Owner's Manual page 257

Choose Auto when getting the IP address from a DHCP
server. The IP address is automatically obtained from the
DHCP server whenever the printer is reset or turned on.
Choose PING when setting the IP address using the
arp/ping command. The print server uses the IP address
set by the arp/ping command. The settings become
available when the printer is reset or turned off and then
back on.
Note:
To use Auto, a DHCP server must be installed and correctly
configured on your computer. See the online help of your
operating system for detailed instructions.
Choose PING only when setting the IP address using the
arp/ping command.
7. Press the Up or Down button until IP = 0.0.0.0 appears.
Press the Enter button.
8. Press the Up or Down button until the desired value appears.
Then press the Enter button to set the value.
Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default
gateway.
9. Turn off your printer and then turn it back on. Be sure to wait
until the initialization is complete.
Print a network status sheet to confirm the new IP address.
Note:
You must first set the IP address before using EpsonNet WebAssist.
See the Reference Guide for more information about settings on the
printer's control panel.
Tips for Administrator
13
13
13
13
13
13
13
13
13
13
13
13
259