Epson 4003353 Service Manual page 97

Adjustments
Move the carnage manually to the right adjust position and repeat steps 3 and 4, referring to
6.
Figures 418 and 419.
Carriage Roller
0.04
mm
Thickness Gauge
4.1.8 Internal Timer Reset Operation
This operation is required when replacing the M-4A1O printer mechanism. There are 6 timers in
this printer:
1. Refresh timer
2. Timer (monochrome and CMY)
3. Flushing level decision timer
4. Fail absorbing timer
5. Total print timer
6. PAUSE timer
replacing the printer mechanism, it is necessary to reset the timers as described here:
When
1. Connect the PC to the target printer and turn on the printer.
2. Execute BASIC on the PC and run the VERXXX.BAS program.
When the main menu appears, choose 'Internal timer reset" by entering "6". This resets the
3.
internal timer. The following message then appears.
4. Press "Y''and ENTER.
5. Press "7" and ENTER.
6. Turn off the printer.
Rev. D
\
G A P
I l l
Front Frame
I
Figure 4-19. Confirming the Gap
1. Destination Setting
2. Head Angle Confirmation Pattern Printing
(Head Front/Rear Vertical Position Printing)
3. Head Front/Rear Vertical Position Confirmation
4. Head Gap Adjustment
5. Bi-D Adjustment
6. Internal Timer Reset
7. END
All parameters of the internal timer
are now reset. Press Y and ENTER
to return to the main menu.
Stylus Color Service Manual
\ I
I
4-17