Lubrication And Adhesive - Epson 4003353 Service Manual

6.3 LUBRICATION
The printer must be lubricated properly when the printer is disassembled for component
replacement, or if the mechanical noise exceeds a certain level. EPSON recommends only the
lubricants listed in table below for this printer, both of which have been tested extensively and
found to comply with the requirements of this printer mechanism. Figure 6-2 shows the lubrication
points.
Type
Oil
Grease
Adhesive
E= EPSON Exclusive product (Not commercially available)
Note)
Table 6-2. Lubrication and Adhesive Points
Ref. No.
(1) Extreme point of the knob (Gear)
Cut for knob on the right main frame
(2)
point
(3)
I
(4)
(5)
I
(6) Shaft located at the center frame assembly (2-points)
(7) Cut point for the CR motor on the base frame assembly (2-points)
(8)
extreme point of the eject roller assembly
(9) Contact point of the pressure spring and washer
(lo)
Right side of the front paper guide
Cut point on the platen roller shaft
(11)
(12)
Oil pad on the carriage
(13) On securing the screw
Do not apply too much lubricant, as it may cause a stain on the mechanism as well as a
malfunction of the mechanism.
Rev. A
AND ADHESIVE
Table 6-1. Recommended Lubricants
Name
o-5
G-20
G-36
Lubrication/Adhesive Point
Part No.
Q'ty
1010513
40 cc
40 gm B700000001
40 gm B703600001
1000 g B730200200
Maintenance
E
E
E
E
Lubricant
G-36 (l-3 mg)
G-36 (l-3 mg)
G-36 (l-3 mg)
G-36 (l-3 mg)
G-36 (l-3 mg)
G-36 (l-3 mg)
G-20 (l-3 mg)
G-20 (l-3 mg)
05 (l-3 mg)
(l-3 mg)