Troubleshooting - Star Trac E-TRx Work Instructions

T
ROUBLESHOOTING
Star Trac recommends that you refer your questions about your STAR TRAC E SERIES TREADMILL operation and suspected mal-
functions to Star Trac's Customer Service Hotline at (800) 503-1221, or USA 1-714-669-1660. However, you may wish to investigate
error messages that appear in the Information Window. You may do so by reviewing the information in this section.
This error generally occurs when a key is held pressed while the
key becomes stuck. When you see
I
Set the switch to
I
Set the switch to
This error generally occurs when the Stop Switch is not connected tightly to the circuit board of the Display Control Panel. It
may also happen if the circuitry associated with the switch develops a fault. When you see
I
Set the switch to
I
Set the switch to
or misaligned relative to the revolutions-per-minute (RPM) sensor of the motor. They may also occur if the speed sensor cable is dam-
aged, or if the Motor Control Board (MCB) is misadjusted or faulty. When you see
I
Set the switch to
I
Set the switch to
of limits, or the elevation motor is disconnected or receiving low power. They may also occur if the Motor Control Board (MCB) is faulty
or the motor gears are stripped. They are usually accompanied by failure of the treadmill to rise from an elevation other than maximum
(or descend from an elevation other than minimum), with attendant beep indication.
42
; wait 2 seconds.
. The treadmill should be operational again. Notify Star Trac if additional assistance is needed.
; wait 2 seconds.
. Notify Star Trac if additional assistance is needed.
These errors generally occur when the running belt speed sensor is disconnected, faulty,
; wait 2 seconds.
. Notify Star Trac if additional assistance is needed.
These errors generally occur when the elevation (incline) potentiometer is faulty or out
switch is moved to
or
STAR TRAC E SERIES TREADMILL O
C
HAPTER
7
. It may also happen if a
' M
WNER S ANUAL