Star Trac E-TRx Work Instructions page 22

I/O Interface
Step 16.
Connect the I/O interface cable (e) to J1 connec-
tor on the translator board located on the top of
the embedded display.
If Equipped, connect the user-detect cable from
the neck to J5 connector on the translator board.
Step 18.
Attach ground strap of the display assembly to
the frame with a screw and washer.
23
User-Detect
Step 17.
Mount the assembly to the frame and note the
screw locations (see picture above). Secure
top assembly with (4) M4 screws and (4) flat
5/16 washers.
Step 19.
Secure the lower left and lower right of the as-
sembly with (1) M4 screw and (1) flat 5/16
washer on each side.
Screw Locations
620-7920 Rev A