Star Micronics SLIP SP298 SERIES Programmer's Manual page 54

CODE
HEX
FUNCTION
Value of n
0 or "0"
1 or "1"
2 or "2"
3 or "3"
4 or "4"
This command is stored, even in line mode, and the position at the
time that page mode is entered is used as the standard point (0,0).
Since the bottom of the character is used as the baseline, a minimum
print area of 8 dots are necessary in the character height direction to
print data in the page. (When printing a magnified character height,
the paper must be fed before printing.)
<ESC> "T"
1B 54
Setting print direction in page mode
Sets the direction in which the printing will be executed in page
mode according to the value of n.
This command is only valid in line mode.
0 rotation mode (uni-directional printing)
270 rotation mode (uni-directional printing)
180 rotation mode (uni-directional printing)
90 rotation mode (uni-directional printing)
270 rotation mode (bi-directional printing)
The default value of n is 0.
<Rotation direction examples>
n = 0 n = 1 or 4
0 rotation 270 rotation
12345•••
ABCDE•••
<N=4,"4": Check high-speed printing mode>
This parameter is only valid when no character data is expanded
into the page area, and this command is added immediately after
<ESC>"n".
Also, once the check high-speed printing mode has been entered
with <ESC>"T"4, it is not possible to move across to a different
rotation mode (<ESC>"T"0-3) until the page mode has been exited.
n
n
Mode
n = 2
180 rotation
ABCDE•••
12345•••
n = 3
90 rotation
51