Star Micronics SLIP SP298 SERIES Programmer's Manual page 49

46
Slip Control
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
<ESC> <SI>
1B 0F
Setting slip sensor
Sets the slip printer TOF/BOF sensor according to the value of n.
TOF Sensor
n = 00, "0" :
01, "1" :
02, "2" :
03, "3" :
The default value is n="0" when memory switch 5-2 = 0 (set when
the unit is shipped from the factory,) and n="3" when memory switch
5-2 = 1.
<ESC> <FF>
1B 0C
Slip function
After printing the data in the line buffer, operates the slip printer
according to the value of n.
n = 00, "0" :
01, "1" :
02, "2" :
03, "3" :
04, "4" :
05, "5" :
(NOTE) When the slip paper is attached to duplicates, a paper jam
may occur if the paper is always fed backward. Therefore,
the paper should not be ejected with n=3. To feed slip paper
attached to duplicates backward, use <ESC> <VT> to set
the eject length to about half of the paper length, then eject
the paper using <ESC> <FF> 5.
n
n
Valid
Valid
Invalid
Invalid
n
n
Operates the clamp
Releases the paper
Releases the paper and waits until it is removed
Feeds the paper backward (backfeed) until it
moves past the TOF sensor, then releases the
paper. (See NOTE below.)
Feeds the paper into the printer (operational feed)
until it moves past the BOF sensor, then releases
the paper.
Feeds the paper according to the direction and
length set by <ESC> <VT> m n (the paper is not
released)
BOF Sensor
Valid
Invalid
Valid
Invalid