Star Micronics SLIP SP298 SERIES Programmer's Manual page 35

32
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
<ESC> "W"
1B 57
Sets the magnification rate in character width
Prints the subsequent data with a character width magnified by a rate
specified by the value of n.
n= 0, "0": Reset magnification (same as <DC4>)
1, "1": Double magnification (same as <SO>)
<ESC> "h"
1B 68
Sets the magnification rate in character height
Prints the subsequent data with a character height magnified by a rate
specified by the value of n.
n= 0, "0": Reset magnification
1, "1": Double magnification
<ESC> "–"
1B 2D
Underlining
When the value of n is 1, underlines the subsequent data including a
character spacing set by <ESC><SP> n.
The part to be skipped by the horizontal tab setting and the block
graphic characters are not underlined.
Resets the underline mode when the value of n is 0.
The value of n can be set to 0(00H) or "0"(30H), or 1(01H) or
"1"(31H).
<ESC> "_"
1B 5F
Upperlining
When the value of n is 1, over lines the subsequent data including a
character spacing set by <ESC><SP> n.
The part to be skipped by the horizontal tab setting and the block
graphic characters are not upper lined.
Resets the upper line mode when the value of n is 0.
The value of n can be set to 0(00H) or "0"(30H), or 1(01H) or
"1"(31H).
n
n
n
n
n
n
n
n