Epson EM07ZS1647F User Manual page 30

2. Installation
(7) Tighten each screw securing the wires on the connector.
Tighten the screw securing the wire at a correct tightening torque (0.25 to 0.3 N·m). To
prevent thick cable from coming out due to cable tension, install enough thick cable
length to allow for stretch.
Use a small flat blade screwdriver that has the correct
width and thickness. If you use a typical screwdriver
whose point is narrow, you cannot deeply insert it into
the hole on the connector.
Specific screwdriver for DeviceNet connector screw:
OMRON
Phoenix Contact : SZF-1 0.6×3.5
18
: XW4Z-00C
Width
Thickness
0.6 mm 3.5 mm
Fieldbus I/O Rev.6