2.7.6 Slave Mode
(1) Ensure that the board is connected to the fieldbus. Then, start the applicomIO
(2) Click on the "Protocol list" under the board that was just added.
(3) Select Protocol | Properties.
(4) Configure the baud rate, MAC ID (slave address), and so on for the DeviceNet
NOTE
(5) Double-click the "DeviceNet Local Slave" item.
Fieldbus I/O Rev.6
console application.
network. In this example, the MAC ID (slave address) is set to 005.
Specify an unused address on the network for a slave device as well as other devices.
2. Installation
37