How To Setup A Ethernet/Ip Network - Epson EM07ZS1647F User Manual

2. Installation

2.5 How to Setup a EtherNet/IP Network

The following is a basic procedure for setting up a EtherNet/IP network:
1. Choose node distribution and distribution route on your network.
2. Lay cables.
3. Configure nodes.
4. Turn ON the nodes.
5. Install the scanner board in your controller.
6. Configure a master and slaves.
7. Configure EPSON RC+.
8. Operate the EtherNet/IP network.
24
For details, refer to the following section 2.6 EtherNet/IP Network Construction.
For details, refer to the following section 2.6 EtherNet/IP Network Construction.
For details, refer to respective manuals of your desired nodes.
Refer to the section 2.9 EtherNet/IP Board Installation later in this chapter.
Use the configuration management software for configuring a master and slaves
(scan list). For details, please refer to the configuration management software
manual.
To configure EPSON RC+ as a master, refer to the section 2.9 EtherNet/IP Board
Installation later in this chapter.
Refer to the section 2.10 EPSON RC+ Fieldbus I/O Installation later in this chapter.
Fieldbus I/O Rev.6